"Drain tank, turn off water and electricity, raise dishwasher 100mm, cut wire tie on drain hose without damaging, take plug out to drain water from tank, undo 3 nuts holding element in place, take out element and seal, replace element with new seal and tighten 3 nuts, connect spade connectors to elements - remember not all 3 elements are used depending on power source capacity, turn on water and electricity, raise bleed hose slightly and let water run through, turn water off, plug hose, use new wire tie electricity off and put hose back gently back in tank flat. put all panels back on lower dishwasher back on ground and in position."
Heating element 6000W 240V mounting ø 47,5mm heating circuits 3 L 325mm W 33mm H 37mm
Location Ref: Pg:41 Item:00007
Exploded diagrams, Schematics and other documents
Power
6000 W
Voltage
240 V
Mounting diameter
47,5 mm
Heating circuits
3
Length
325 mm
Width
33 mm
Height
37 mm
Number of thermostat sleeves
1
Diameter thermostat sleeves
5 mm
Length thermostat sleeves
140 mm
Position thermostat sleeve
centre not clinging
Tube diameter
8,3 mm
Hole distance
62 mm
Hole diameter
10 mm
Connection
male faston 6.3mm
Mounting
3 hole flange
Application
immersion heater
Installation
Michael
NSW
"Drain tank, turn off water and electricity, raise dishwasher 100mm, cut wire tie on drain hose without damaging, take plug out to drain water from tank, undo 3 nuts holding element in place, take out element and seal, replace element with new seal and tighten 3 nuts, connect spade connectors to elements - remember not all 3 elements are used depending on power source capacity, turn on water and electricity, raise bleed hose slightly and let water run through, turn water off, plug hose, use new wire tie electricity off and put hose back gently back in tank flat. put all panels back on lower dishwasher back on ground and in position."
Scott
NSW
"Turn off the washer and remove the plug from the power socket, remove front and side panels of the washer, remove the power cables from the heating element. document the cable colours and the connector position from which they came. remove three nuts holding the heating element. allow the water to drain from the tank. remove the element, replace the new element and assembly is the reverse of the above"
Scott
NSW
"Turn off the washer and remove the plug from the power socket, remove front and side panels of the washer, remove the power cables from the heating element. document the cable colours and the connector position from which they came. remove three nuts holding the heating element. allow the water to drain from the tank. remove the element, replace the new element and assembly is the reverse of the above"